**If you file down our DNA 75/250 mounting kit posts to 5.25mm then our actuators work with this board. This leaves the screen 1.3mm recessed on a standard 1.9mm wall gbox type enclosure. We'll work on getting some 5.25mm posts produced**
ModPCB and Voltrove teamed up to bring you the new "NLPWM" board, and it's finally here!
The NLPWM board is a variable voltage, all in one regulator(straight PWM) board where you actually select the output voltage(RMS) instead of just the duty cycle! It sports an on board 0.28", 3 digit, 7 segment display, on board fire/up/down switches and two N channel MOSFETs. Only 3 wires to the board!
Features and specs:
Input voltage = 2s-4s(Automatically detected)
Low voltage cutoff = LiOn + LiPo(user selectable)
Check unloaded voltage - Works like a standard voltmeter
Check loaded voltage - Keep an eye on battery sag + drop!
Output voltage selection increments = 0.1v
Output voltage min = 1v
Output voltage max = last loaded battery reading
Output voltage accuracy = 5%
Switching Frequency = 244hz
Dimensions = 19x83.5mm
Display Color = White(Blue and Red coming soon!)
Idle drain = 380uA
Recommended load current = 60A
NOTE: The NLPWM board doesn't limit current or have any over current protection, so it should be added off the board. Be very careful working with high current!