This enclosure is pre milled for a dna250c and intended for use as a 2s 21700 build. It has two lids, the rear lid being a false lid purely for asthetics and symmetry. This listing is for the box only
LIDS ARE SOLD SEPARATELY - Please check the Custom Lids category for suitable lids
Suitable for Evolv DNA250C ONLY, DNA75 BOARDS WILL NOT FIT
510 threaded for 30mm Source 510's only (M12x1
Threaded cutout for 12mm switch with M12x0.75mm thread. We recommend clontec switches
Magnets supplied but not fitted. See note below about stacking the box magnets
Laser etching is available on request
Intended as a 2s build using a MosMax 2x20700 battery holder so suitable for 20700 or 21700 cells
Lids are sold separately as we intend to produce several options from acrylic or you might want to make your own. If you want to make your own we've prepared a dxf which is available HERE
To use this enclosure the way we intended, you'll need our blanked dna250c acrylic board holder and a mounting kit, both of which come free with a board purchase.
Source 30mm 510 Connector
Correct actuators are available here. More variations will be available soon
Suggested Balance wiring
Use 1mm solid copper wire to bridge the balance contacts
Out magnet supplier messed up so to fit the supplied magnets in the box you will need to stack a 3mmx1mm magnet under a 3.5mmx2mm magnet as showin in the below image.